Hello all. I'd like to make a panel that looks like this to cover the false floor in my next build:
The panel will be made of 3/4" MDF. It will be wrapped in black and blue automotive carpets. My question is how to make this pin stripe. I picture cutting a small channel in the MDF length wise between the colors using a router or table saw. I would glue the black carpet down, stuff the carpet edges into the routed groove, then run a knife inside the groove to trim the carpet. I could then lay the blue down (slightly overlapping the black) and do the same thing.
Does this make sense?
Do you have any comments or better ideas?
Ge0