I've got a budget of $1,000. That should be more than enough.
Loving the build, especially the RCA's and the use of the security screws! Although, for me, I'd have to stock up on security bits for fear of losing them LOL.
On a personal level, I'm terrible with names, but I believe we met at bertholomeys May GTG... I think you were driving a 4 Runner and brought your wife, do I have that correct?
Whew! Good, would have felt silly if I was wrong... Eric here, I was the guy all hunched over using the cane.
I made some more progress on the car this weekend. I still have a lot to do but it’s getting closer. Everything in the trunk is at the level of the factory floor with the exception of the subwoofer. It sticks up approximately 3/4” above the factory floor. Everything except the sub is protected by plexiglass.
I started doing the wiring. All wires will be protected with techflex and secured with zip ties every six inches or less and attached to the floor to make sure nothing moves. Any splices are made via solder and heat shrink.
The cover panels are press fit and I can get to any fuse by removing one or two screws. I used Phillips head screws on the plexiglass to make it easier to remove in case of an emergency. All components are secured using tamper resistant torx head screws. Screws used to mount the subwoofer are temporary until I find some #8 x 2” security screws.
Sent from my iPhone using Tapatalk
I've got a budget of $1,000. That should be more than enough.
Very cool that you managed to squeeze all that below the factory carpet and can fit you bike in there no problem... Nice work!
The lengths some folks go to ! .
I thought I was smart when I flocked the tweeters . . .
Before I used the gum
Last edited by Queef; 12-02-2019 at 08:43 AM.
That doesn't look half as shitty as I thought it would...good job!