Hello All,
My name is Tim, getting there in age, commuter and bass lover.
Found this forum online and have been reading tons of build logs. Starting my first build myself and have been looking for inspiration across the net. All of the posts and replies here are friendly and supportive and I joined because of that!
Car: 2006 Ford Fusion SE V6
Current Equipment:
- Kenwood DPX303BT head unit;
- Rockford Fosgate P1683 Coax front door speakers - can handle 65W RMS
Build components:
- 1000.1 PRD Memphis Amp, 300W RMS @ 4 ohm; (bought used from a friend)
- MTX Thunder Pro 2/ 180W, 60W RMS @ 4 ohm 2 channel; (found at local Best Buy... left over from when it was a Future Shop... 40$ couldn't resist).
- JL 10W3 Subwoofer in 32hz tuned ported box. (bought used from a friend)
- Noico 80mil 50 sq ft. sound deadening
Install equipment:
- 0 gauge power (memphis)
- 0 gauge ground
- 8 gauge power (MTX)
- 8 gauge ground
- 4 RCA's
- Speaker Wire
- Distribution block (0 to 4&4 but i will be doing 0 to 4&8. Swapped the fuse for the 8 gauge)
- termination blocks
- Remote turn on x 2
- in line power fuses\
I was worried that the used memphis amp would blow the speakers out of the water. But after some quick calculations looks like I will be on the low side of acceptable at 300W:
And this is how it SHOULD all go together
I start tomorrow! Let me know your thoughts and advice as this is my first real build with amplifiers and subs