....
Yep, that's exactly the right range - two comments/questions:
Why do you say this - and even the eight inch version (that's what made my eyebrows raise) - wouldn't be a good choice for midbass? Granted, I haven't checked out the spec sheet yet - but we're basically looking for something that has equivalent-or-better midbass than a typical component set 6.5, since that's exactly what this will be augmenting. It doesn't need to be a subwoofer. But if it starts rolling off at 300hz on the low end, then yeah - that wouldn't be great. I'd really be shocked if that was the case though. Is it? Do you know the Fs? I think I need the spec sheet on this guy...
Also, you probably haven't looked - but there aren't that many 4-ohm DVC 6.5's out there. At a glance, I was impressed at what they found - the RF and the SI. I'd been finding Boss and Pyle.
Any suggestions for one?
Honestly, since we don't need much power handling, and since we really don't even need to care that much about fidelity in that midbass region, and don't need big Xmax like a subwoofer, I was even thinking some turd like a Boss or Pyle might even be just fine for this, provided the Fs was low enough. And if that sucked - little lost, can always replace it with a better one.
But yeah - I'd be pissed if I spent $80 on a throwaway 6.5. So definitely interested to hear your thoughts, and thanks.
EDIT: Never mind... I looked for the specs myself, and see this is NOT a dual voice coil 6.5. We need that, so we can run it "stereo", if you will.