So as I prepare to replace my RF DSR-1 DSP with a Helix DSP.3, I need to "re-configure" the board I have my amp and DSR-1 mounted to. SInce I'm going to need to move where the amp is installed and remove the DSR-1 from the board and replace it with the DSP.3, the holes will need to be in different locations, etc (I drill holes in the board where the wires go underneath the board). So... My original board was black particle board (left over from a computer desk that I had torn apart). I no longer have any pieces of that big enough, so I am using a piece of finished wood instead (from an old coffee table) - but the finish isn't in very good shape and I'd rather it be black anyway.
I just happen to have a can of black plastidip laying around. Do you think it would be OK for a Helix DSP.3 and JL Audio amp (class D) to be mounted onto a plasti-dipped board? I'm just not sure if the amp and/or DSP could get too hot and cause issues with the plastidip or not...
Thoughts? Should I just go and get a can of black spray paint instead?
Thanks.