Custom High-End Focal Stereo Upgrade in a 2022 Ford Tremor with B&O

[SoundsGoodStereo]

Equipment Details:


Factory Radio of course


Source Integration: Nav-TV Zen A2B
Speaker Interface: APH-FD02
Front Speakers: Focal Flax PS165F3E 3-Way Components in custom A-Pillars
Front Door Plates: Ten87 Design Block Off Plates
Front Speaker Adapters: Ten87 Design
Rear Speakers: Focal Flax PC165FE Coaxials
Front Speaker Amplifier: Mosconi 100.6 One Series
Subwoofer Amplifier: Mosconi 1000.1 One Series
Rear Speaker Amplifier: Mosconi Pico 2
Amplifier Rack: Ten87 Design
RCA Cables: Custom made Straight Wire Cables
Sound Treatment: BlackHole MAT 3-Layer CLD + SQL Audio Soundwave Closed Cell Foam Rings
Backwave Control: BlackHole Tiles (144 Total Tiles)
Electrical: Full-Length Power + Ground iConnects 1/0 Gauge into two Distribution Blocks
Subwoofer: One 10-inch Focal K2 Power E25KX
Custom Enclosure: Vented tuned to 33hz, factory fit and finish with laser etched RGB lighting with the Tremor logo


All of this was tuned utilizing the Mosconi 8to12 Aerospace DSP.


Any questions, post below!

[BenevolentDictator]

I have a question that's not related to this very nice install...but it is in regards to the Mosconi amps. Since you guys work with them pretty frequently, what are your thoughts on running an AS 200.4 bridged to 2 ohms to run my sub stage? Would that be something that may be too overtaxing on the amp? I'm by no means an SPL monster but I do like to lean on my amp and subs a bit with songs that dip low into the frequency range.

[Jdunk54nl]

Welcome Sounds Good Stereo!

[SoundsGoodStereo]

That should work good. Just keep the amplifier fed with air and electricity We have not used the AS in many years, but they worked great when we used them.