Results 1 to 5 of 5

Thread: Helix Auto Time Measurement

  1. Back To Top    #1

    Helix Auto Time Measurement

    I went through the process, or tried, of performing the Helix Time Measurement. Followed all of the steps yet it failed due to not getting the volume into the "green" acceptable area. Thats even maxing out to full volume before distortion. Anyone else have this issue?

  2. Back To Top    #2

    Re: Helix Auto Time Measurement

    Check the gain on the mic in sustem settings on the pc, it’s a box in rew. So I presume there’s the same on windows itself

  3. Back To Top    #3

    Re: Helix Auto Time Measurement

    Thanks, I will look. Makes perfect sense.

  4. Back To Top    #4
    Noob Stycker's Avatar
    Real Name
    Brian
    Location
    Pittsburgh
    Vehicle
    2020 Subaru Outback XT
    Posts
    237
    Join Date
    Jan 2020

    Re: Helix Auto Time Measurement

    Make sure there are no linked channels. Even have to unlink virtual channels. Make sure Mic loaded into DSP.

  5. Back To Top    #5

    Re: Helix Auto Time Measurement

    I was told the calibration file didn’t need to be loaded for the ATM. Just for the RTA. I ran it today and it seemed to have worked. The first few times it ran successfully but didn’t save the delay readings even when prompting them to save. I made sure Time Measurement was checked on the front page of the Time tab and then chose Time Delay on the settings page of the Time tab and it worked as it should. Thanks!

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Back To Top