So this box will be on the fancy side (hopefully)! Below is a simple dropping to give you an idea... The box will be birch plywood with LEDs recessed into the panels and glowing where you see the yellow highlighter. There will be solid 3/4" thick walnut panels outlined by the LEDs, and the lights will carry around the sub. The flat surface that are recessed will be brushed aluminum. Not sure if that makes sense... I can see it in my mind, but it's hard to put in to words! Lol
Sealed at about 1.0 cuft. About 32" wide x 14" high x 9" deep.
Btw, I'm open to any other ideas to make this thing cool and fancy... There is no budget, so materials and finishes are wide open.
There will be a matching amp rack with the same carpet, aluminum and dark walnut. The rack will have a MiniDSP on the back, and two Toro Tech amps over it...