So the two CCi-44 amps haven't shown up yet, but I have the CC-1000 which is simply longer, so I can use that and a little basic math to lay out the amp rack so everything fits.
It's going to be extremely tight, for this hinged part.
In hindsight, I probably should have opted for shorter RCA cable connectors - I am going to need to buy two right angle RCA ends to make my main long RCA run - that should buy JUST enough room.
It looks like this RCA cable should bend enough without stressing it.
I'm going to design a riser for the miniDSP that has 11 canals in it to route the RCA cable right back under - That will minimize my need to sharply bend my 4 gauge. Possibly I'll design it to also hide the 4 gauge pass-through [to the bottom chamber], but part of my reason for raising the miniDSP is also for air flow from the fan that the miniDSP will be in front of. So we'll see.
I now need to decide whether I'm routing the RCAs under the bottom of the amp rack or down the side on the inside-
I may have just been crowded into deciding to run them through and below.
At least that little rear fill amp won't be a problem.
Sent from my LM-G820 using Tapatalk