Will a bananna plug fit into a terminal cup?

[mikeyt]

Not sure if it will, just thought I'd ask cause I've never tried it before. I wanted to be able to move my box in and out if possible. I didn't think this all the way through I guess. I already built the box and cut the holes and then had the after thought. No big deal I guess if not, I could just wire it like normal, or make a pigtail with them. Just don't like the extra connections that's all.

[Justin Zazzi]

If it fits and it works, then you should be good right?

When the box is removed you'll have the bare ends of the banana though, might want to insulate them or turn the amp off?

[mikeyt]

Yeah, get some type of cap or something? I didn't know if the spacing between both male terminals and female receptacles of the terminal cups were the same

[BigAl205]

I suggest the Neutrik Speakon connectors

https://www.parts-express.com/neutri...mount--092-052
https://www.parts-express.com/neutri...mount--092-050

[Euphonic]

I suggest the Neutrik Speakon connectors

https://www.parts-express.com/neutri...mount--092-052
https://www.parts-express.com/neutri...mount--092-050

Me too.

[mikeyt]

That would be good except that the hole is already cut, this was an after thought so if I can get a plug to fit the spacing of the terminals then I'll go that way. I don't like having extra connections, but if I have to I'll make a pigtail. I can still use what I have, which is fine, I just thought about giving it some flexibility with moving in and out.