Page 2 of 2 FirstFirst 12
Results 11 to 12 of 12

Thread: 2019 F250 Crew Cab

  1. Back To Top    #11

    Re: 2019 F250 Crew Cab

    Ok, I am not trying to throw another wrench into things, but by looking at JL's website, the amp can handle the speaker inputs that you would be giving it, without the use of the LOC. There may be no need for a specific piece of equipment. I hope this is helping and not getting in the weeds too much.
    This is from the website:
    Analog Input/Pre-Out Harness
    The Analog Input Harness accepts the following connections:
    Line-Level Analog Inputs:
    Six female RCA jacks feed a differential-
    balanced input section, providing a high degree of input flexibility, and
    retaining superior noise rejection. This type of input architecture also
    allows the VX700/5i to cleanly accept any analog audio signals up to 16
    VRMS, without using a line-output converter.
    Preamp Outputs:
    Two female, RCA jacks deliver line-level, analog audio
    outputs (Max 4 V RMS) that are compatible with most types of aftermarket
    equipment. These are configured with the TüN

    Software Interface.
    Remote:
    This connection provides a positive (+12V) turn-on voltage
    (475 mA limit) to activate other aftermarket equipment (similar to an
    aftermarket head unit’s remote turn-on lead).
    Valet:
    When connected to negative ground, this input activates the
    Valet Mode Preset and will remain active until the ground connection is
    removed. This preset is configured
    using the TüN




  2. Back To Top    #12

    Re: 2019 F250 Crew Cab

    Quote Originally Posted by carney64 View Post
    Ok, I am not trying to throw another wrench into things, but by looking at JL's website, the amp can handle the speaker inputs that you would be giving it, without the use of the LOC. There may be no need for a specific piece of equipment. I hope this is helping and not getting in the weeds too much.
    This is from the website:
    Analog Input/Pre-Out Harness
    The Analog Input Harness accepts the following connections:
    Line-Level Analog Inputs:
    Six female RCA jacks feed a differential-
    balanced input section, providing a high degree of input flexibility, and
    retaining superior noise rejection. This type of input architecture also
    allows the VX700/5i to cleanly accept any analog audio signals up to 16
    VRMS, without using a line-output converter.
    Preamp Outputs:
    Two female, RCA jacks deliver line-level, analog audio
    outputs (Max 4 V RMS) that are compatible with most types of aftermarket
    equipment. These are configured with the TüN

    Software Interface.
    Remote:
    This connection provides a positive (+12V) turn-on voltage
    (475 mA limit) to activate other aftermarket equipment (similar to an
    aftermarket head unit’s remote turn-on lead).
    Valet:
    When connected to negative ground, this input activates the
    Valet Mode Preset and will remain active until the ground connection is
    removed. This preset is configured
    using the TüN



    That’s very interesting and a great find! I’m curious if it would be recommended or not to install the LOC.


    Sent from my iPhone using Tapatalk

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Back To Top