GB10 vs GB15 sound quality

[Dan17ExplLtd]

If you could run either which would you choose based on sound quality? They would be getting 100 watts and crossed at 2500 l/r24.

[SkizeR]

15 for 2 way, 10 for 3 way

Sent from my SM-G975U using Tapatalk

[Cutaway]

Not trying to hijack your thread but I had a similar question. of the two below 1" tweeters (Brands not important) is there anything below that really distinguish these two? Does one stand out as "better" than the other in a 3 way configuration?

[Dan17ExplLtd]

I get that's what they are designed for, what I'm asking is if there would be a sound quality difference if the 15s were used in a three way.

ZR800, gb40, gb15 for example.

[SkizeR]

Not trying to hijack your thread but I had a similar question. of the two below 1" tweeters (Brands not important) is there anything below that really distinguish these two? Does one stand out as "better" than the other in a 3 way configuration?

Would need more measurements (distortion) to say which separates one from the other

Sent from my SM-G975U using Tapatalk

[Jdunk54nl]

The only difference is that the gb10 will be able to play higher without beaming. But you are getting into 10,000hz+ before it becomes an issue.

Also, you have to realize that for this to make a difference, all other things that you do have to be done properly. So eq done right, phase 100% lined up, levels matched, install angle done right, etc. If you don't have that stuff done, then going from the gb15 to a gb10 isn't going to make anything magical happen.

[JCsAudio]

I have both and what SkizeR said.