Results 1 to 4 of 4

Thread: amp problems

  1. Back To Top    #1

    amp problems

    so i finished my build, I have two 4 ohm Sa v.2 down to 1ohm wired to a banda 3000.1 my amp will go into protect mode when I hit loud volumes when i play downloaded music off my phone but when I play music off of youtube i can push it a lot harder, im kinda of confused, any one have any ideas, I grounded it to the body of the trunk and my power wire is hooked to the battery. tomorrow morning im going to test the ground.

  2. Back To Top    #2

    Re: amp problems

    romajiro,

    Your amp is maybe ? Getting stresses from maximum current draw [ turn volume down ]

  3. Back To Top    #3

    Re: amp problems

    so I checked the ground it was good, but my battery will drop below 12v when it hits hard, so im going to do the big 3 upgrade and get a better battery next week or so.

  4. Back To Top    #4
    Noob JCsAudio's Avatar
    Real Name
    John
    Location
    Massachusetts
    Vehicle
    See signature
    Posts
    656
    Join Date
    Aug 2019

    Re: amp problems

    Different music sources have different loudness levels. Guessing this is more of an SPL setup.
    Mazda CX5 AF GB10, AF GB25, AF GB60, JL VX800/8i, AF GB12 sealed, Mmats M1400.1

    Ford F150
    AF GB10, AF GB25, JLC5, JL twk88/Pioneer D8604, Mosconi Pico, JBL Club 5501, Sundown SD3-10 ported @ 30 Hz

    Sienna
    AF GB15, Audiofrog GS690, JL twk88/Pioneer D9500F, JBL GTX500, Alpine SWS10 ported @ 31 Hz

    https://www.diymobileaudio.com/threa.../#post-5608901






Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Back To Top