Page 47 of 47 FirstFirst ... 37454647
Results 461 to 466 of 466

Thread: Ask an Acoustic Engineer (me)

  1. Back To Top    #461
    Senior Member Euphonic's Avatar
    Location
    SOSIQUIL
    Vehicle
    2016 Ford Escape SE & 2020 Nissan Rogue SV
    Posts
    4,084
    Join Date
    Feb 2015

    Re: Ask an Acoustic Engineer (me)

    The steering wheel controls possibly operate through the CAN Bus. Not sure what colors, could be a twisted violet/orange and gray/orange. You’ll need something like an AXSWC to interface your new stereo. As far as the OE mic, you might be able to tap into the wires at the mic, but it may lack the sensitivity to be used with your stereo.

  2. Back To Top    #462

    Re: Ask an Acoustic Engineer (me)

    Quote Originally Posted by Jdunk54nl View Post
    That info should be available with a wiring diagram. You can get 48hr (or something like that) access for under $20. Grab all the electrical diagrams you need and you should be able to find your info.
    I’ve looked high and low for a pin diagram that made sense and haven’t found one. That’s why after hours of searching I then searched for car audio ask an expert pages. I hoped that you or someone here has wired a 2011-2016 Ford Truck aftermarket stereo and could provide some insight.

  3. Back To Top    #463

    Re: Ask an Acoustic Engineer (me)

    Thanks for the reply, I will have to locate this CAN bus and purchase the controller interface. I’ll let you know if it works!

  4. Back To Top    #464
    Noob Jdunk54nl's Avatar
    Real Name
    Jacob
    Location
    Phoenix
    Vehicle
    2014 F150 Limited
    Posts
    1,060
    Join Date
    Oct 2019

    Re: Ask an Acoustic Engineer (me)

    Quote Originally Posted by 2015TexasSuperDuty View Post
    I’ve looked high and low for a pin diagram that made sense and haven’t found one. That’s why after hours of searching I then searched for car audio ask an expert pages. I hoped that you or someone here has wired a 2011-2016 Ford Truck aftermarket stereo and could provide some insight.
    I just looked on alldata and they have 1 month subscription for $19.99. They will have what you need if you find the proper diagram for what OE equipment you have.

    Mic looks like it is a yellow green wire for mic+ and black for shield going into APIM.

    The steering wheel stuff is more complicated and you'd have to look at it and figure it out. But on alldata it is 130-020 and 130-021 Audio System/Navigation diagrams. Or if you go to the electrical - interactive Color (Non OE) diagram, it is easier to trace all of that stuff.
    2014 F150 Limited -> Kenwood DDX-9907xr -> Helix DSP.2 -> Alpine PDX-V9 -> SI M25 mki in Valicar Stuttgart Pods, Rear SB17's, Sub SI BM MKV's in MTI BOX. Alpine PDX-F6 -> SI Tm65 mkIV, SI M3 mkI in Valicar Stuttgart Pods

  5. Back To Top    #465
    Senior Member Euphonic's Avatar
    Location
    SOSIQUIL
    Vehicle
    2016 Ford Escape SE & 2020 Nissan Rogue SV
    Posts
    4,084
    Join Date
    Feb 2015

    Re: Ask an Acoustic Engineer (me)

    Have you tried going here https://axxessinterfaces.com/ here http://metraonline.com/ or here https://pac-audio.com/ and inputting your vehicle info to see what kind of interfaces are available?

  6. Back To Top    #466

    Re: Ask an Acoustic Engineer (me)

    Quote Originally Posted by Euphonic View Post
    Have you tried going here https://axxessinterfaces.com/ here http://metraonline.com/ or here https://pac-audio.com/ and inputting your vehicle info to see what kind of interfaces are available?
    Thanks guys, good info here. Those damn controllers are as much as the new stereo. Crazy.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Back To Top