Page 3 of 3 FirstFirst 123
Results 21 to 24 of 24

Thread: About that Harmon DSP that was cyptically mentioned during CES ...

  1. Back To Top    #21

    Re: About that Harmon DSP that was cyptically mentioned during CES ...

    Exactly correct! Always make sure to load your profile before you connect the Comm port!

    A few caveats I learned after talking with Harman Specialist.

    The chip has a bit rate of 192khz and uses a Finite Impulse Response Filter or FIR vs an IIR. One of it's limitations is it's limited to Butterworth digital alignments.

    It is fairly easy to use really. I'd watch a few videos of setting up a DSP. Arc just put out a decent beginner guide.

    I should also mention that in my previous post I said all outputs to +6db that was incorrectly stated.... All USED outputs were at +6DB so only 4 channels were driven when I tested it.

  2. Back To Top    #22
    Senior Member Smitty's Avatar
    Location
    FL
    Vehicle
    2019 Toyota 4Runner, 2019 Toyota Camry
    Posts
    271
    Join Date
    Oct 2019

    Re: About that Harmon DSP that was cyptically mentioned during CES ...

    I will add, I'm connected to a factory Toyota head unit. I have to pull down the large bumps in the OEM eq to compensate for some large dips which results in bringing down the overall output.

    This amp is clean enough that I'm running my midrange and midbass at +3 db and the master volume at 0 db. Running a 0 bit CD track, I have to try to hear background hiss with the engine off and quiet. I could even hear the faint spinning of the CD drive. I am very pleased with the very low noise floor in an affordable product. I could probably even bump the output more but I'm already at more than enough volume for my listening.
    Meh, it'll play.

  3. Back To Top    #23

    Re: About that Harmon DSP that was cyptically mentioned during CES ...

    Did you ever hook up to rcas and feed another amp?
    I haven't had the time to dig in on my bike other than letting it sing as it's already hooked up ��.

    If so what did you figure out the DB level was in relation to the settings?

  4. Back To Top    #24
    Senior Member Smitty's Avatar
    Location
    FL
    Vehicle
    2019 Toyota 4Runner, 2019 Toyota Camry
    Posts
    271
    Join Date
    Oct 2019

    Re: About that Harmon DSP that was cyptically mentioned during CES ...

    Quote Originally Posted by Shane35Fowler View Post
    Did you ever hook up to rcas and feed another amp?
    I haven't had the time to dig in on my bike other than letting it sing as it's already hooked up ��.

    If so what did you figure out the DB level was in relation to the settings?
    If you are asking me, no, I haven't yet. I haven't touched my system in quite a while. Life has been hectic.
    Meh, it'll play.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Back To Top