Results 1 to 5 of 5

Thread: Nissan 370z SQ Competition build -Extreme Class

  1. Back To Top    #1
    Junior Member
    Real Name
    Ken
    Location
    NorCal
    Vehicle
    2017 Nissan 370z
    Posts
    11
    Join Date
    Feb 2020

    Nissan 370z SQ Competition build -Extreme Class

    Last season I had the car completely rebuilt. You may have seen it on Bespoke Mobile Audio's facebook page.


    BMA did a wonderful job of the front stage build, we ripped and replaced everything in the car and went with:


    Scanspeak Illuminator 15WU - Mid / Midbass duty
    Scanspeak Revelator R2904 - Highs
    SB Acoustics 12" 4ohm - Sub


    Tru Technologies TG2 - Su
    Tru Technologies TG2RS - Mids
    Tru Technologies TG4RS - Highs/Rear
    Tru Technologies 8ch Line Driver.


    Helix DSP Pro Mk2 for DSP duty.


    The trunk was built fairly utilitarian by myself, and features:
    2 Full Throttle batteries
    Harrison Labs 2x100A Fluxcapacitor
    All the amps and LOTS AND LOTS of wire mess.




    Some build Photos:


    Completed A Pillars with the 15W and R2904





    The money shot



    Yes there is very little room for feet in the passenger area:





    Simple Amp rack for the hatch area.



    Batteries and Harrison installed, wiring in progress



    carpeted beauty plate in place.



    Overall I really enjoy this setup, I finally scored into the 80s in Extreme class (moved up from Street).


    This 2020 season more changes are coming!

  2. Back To Top    #2
    Junior Member
    Real Name
    Ken
    Location
    NorCal
    Vehicle
    2017 Nissan 370z
    Posts
    11
    Join Date
    Feb 2020

    Re: Nissan 370z SQ Competition build -Extreme Class

    This season I'm going to attempt to move the subs to the trunk again, I did some mock ups of 8" kicks and was pleasantly surprised that they would fit reasonable well.


    The current plan of record is:

    • Run 8" mid-bass in the front and get my passenger footwell back. It really sucks giving demos when you're a big guy in a small car...
    • Pull everything from the trunk, drop in 2x 12" Adire Tumults to handle all the "DO IT BANG" activities.

    Obviously this is going to require MORE POWER, so I'm evaluating amplifier options. Class-D is looking pretty nice.


    I cut the dead pedal out, and removed the huge foam footrest. I was pleasantly surprised when the foam left behind a gaping hole. I then glassed in the driver's side panel last weekend and tested the general fitment of an AD w800neo.





    I then trimmed up the fiberglass, and wrapped with fleece. to visualize the space better, measured roughly 4L of airspace without the driver. This should be reasonable considering winisd had a nominal space of 3.5L for this application. I'll be adding a coat of bondo/resin mix to close the volume gap more accurately.





    Overall fitment was decent, lots of room for the clutch pedal. I need to add some glass to give the pod a more finished look.


    This weekend I'll pull the front sub, mold in another kick pod and start finishing work. Then on to the trunk re-build.

  3. Back To Top    #3
    Noob JCsAudio's Avatar
    Real Name
    John
    Location
    Massachusetts
    Vehicle
    See signature
    Posts
    656
    Join Date
    Aug 2019

    Re: Nissan 370z SQ Competition build -Extreme Class

    Looks like you put a lot of hard work into that car.
    Mazda CX5 AF GB10, AF GB25, AF GB60, JL VX800/8i, AF GB12 sealed, Mmats M1400.1

    Ford F150
    AF GB10, AF GB25, JLC5, JL twk88/Pioneer D8604, Mosconi Pico, JBL Club 5501, Sundown SD3-10 ported @ 30 Hz

    Sienna
    AF GB15, Audiofrog GS690, JL twk88/Pioneer D9500F, JBL GTX500, Alpine SWS10 ported @ 31 Hz

    https://www.diymobileaudio.com/threa.../#post-5608901






  4. Back To Top    #4
    Procrastinator beak81champ's Avatar
    Real Name
    Bobby K.
    Location
    Springfield, Illinois
    Vehicle
    2013 Camaro 2SS/RS
    Posts
    798
    Join Date
    Nov 2015

    Re: Nissan 370z SQ Competition build -Extreme Class

    Lookin’ awesome!
    Kenwood DDX9903S, Arc PS-8 w/PSC, Arc Audio 1200.6, Helix SPXL1000, Audiofrog GB12D4(2) IB, GB60, GB25, GB10

  5. Back To Top    #5
    Junior Member
    Real Name
    Ken
    Location
    NorCal
    Vehicle
    2017 Nissan 370z
    Posts
    11
    Join Date
    Feb 2020

    Re: Nissan 370z SQ Competition build -Extreme Class

    Quote Originally Posted by JCsAudio View Post
    Looks like you put a lot of hard work into that car.
    Bespoke Mobile Audio did most of the interior stuff, but over the next few weekends I'm going to be re-building the subs/kickpods/etc.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Back To Top