The subs have arrived unharmed from across the land! I have also done a bit of a swapsie with a couple of st-4sq I had kicking about for a hybrid audio U1A as it will be about right for a pair of dual 2 ohm subs in IB... the frame is currently being knocked up to be welded into the wheel well and then a large hole cut out
so the plan is as follows... unity amp at the very rear most edge of the boot (infront of the latch), a pair of inverted twelves in a manifold at each rear corner of the boot, lithium pack in the centre between manifold and seat as low down as possible...
then the dsp with exposed cabling in the centre also to show off the leads and orange techflexed cables
then the cherry on top will be the biggest ass zapco over the lot (the boot is 20” deep of not a touch more), and a 15 fitted with 3” to spare to the front edge of the boot... loadsa room (he says!!)
trim will be orange under the dsp (and maybe in recessed rings under the subs) so the helix ultra pops, and black vinyl or charcoal (or black) alcantara over the rest of the panels... the big zapco might end up floating on edge lit perspex just yet