Sexual intercorsa...

[preston]

I went back and re-read the post where you covered this, so never mind.

[dumdum]

I was actually confused for a moment I thought you were sinking drivers into the dash and covering the whole affair with grille cloth (I think I mistook that big round boot for a driver in one of the photos). But now I realized you are still running the pods but removed the dash solely to reduce reflections. Did you determine this primarily by listening ? Was there any measurements that reinforced your decision or did you just find it staged much better with the dash top removed ? Have to admit that's pretty hardcore, kudos man.

The tablet mount is impressive -; A bit dominant, could be a theft target, but fabrication looks great.

Yes by listening to the left side midrange and tweeter solo’d and together also, with a dash the left of stage cane inwards to approx 12” across from the pillar and half way up the screen (it gave excellent height on the left of stage... but not when the right is eye level... sloping stage anyone...

basically I made the pods for 6” before with similar aiming with no dash and got excellent width, then made the 5” pods around a dash... it messed up the left So I cut the dash top off once more and got my left back, so I had to create a dash that’s not a dash but looks like one 👍🏼 Different but I bought the car so I could create art and not worry about the cars cost 👍🏼 I do like the new scan D3004/602000 Tweeters, very nice with a bit more refinement than the sb acoustics

[dumdum]

Where to start... pics tell a thousand stories! The iPad decided it wouldn’t charge on the end of a lead... i hollowed our the 12mm ply with a router by hand and made some space for it to fit and the leads come off it

[SiW80]

Try a lightning cable extender if the CCK cable is too thick to bend


Sent from my iPhone using Tapatalk

[dumdum]

Try a lightning cable extender if the CCK cable is too thick to bend


Sent from my iPhone using Tapatalk

An extension was the lead it wouldn’t charge on the end of, the cck3 was gonna be at the base of the centre console, but I needed to move the cck3 to plug direct into the iPad

[dumdum]

More pics...

[dumdum]

A few lore pics, the slit at the bottom of the clocks was so I could trim them in one piece

[dumdum]

More... the circle jig was set to 1.05m radius so I could cut three slightly curved ribs for the top of the clocks To give it shape, chuffed how they came out

[dumdum]

More pics, I decided to take the bottom end crossover off the 6x9 and see where they’d play to... it surprised me, a pair of full depth hybrid audio u69v2 installed IB under the seat front edge rising all the way to 20hz

and the finished look! Well happy with 100+ hrs work

the fingers are a combination of superglue and hot glue after trimming the clock binnacle

[dumdum]

I should add that once the iPad mount has been given some shape I will then repaint the entire Heater upwards console In gloss black