Hey junkies - Really appreciate some help with audio setup!

[m4kk]

Hey guys, I am completely clueless when it comes to car audio and would appreciate some/a lot of help.

So the audio system is for a Mitsubishi Colt. Boot space very very limited.



I'd like to get some amped components up front and a sub for bass in the rear.

Was going to go for these components, they have to be 13cm/5.25''

Infinity Kappa 50.9cs

Now, I have no idea which amp I'd need to get the most out of these, a 4 channel for a sub as well? Or a 2 channel + a mono for the sub?

Regardless, any reccommendations for a sub and amp? and are these actually good components?

Thanks, budget for amp depends if I need 2? maybe 200$ tops and 200$ for sub, will this give me a good punchy system?


Regards, as I said absolutely clueless, any advice appreciated.

[Queef]

Sub recommendation : https://www.parts-express.com/peerle...-ohm--264-1492

Pioneer GM amplifiers :
https://www.sonicelectronix.com/item...MaAnPsEALw_wcB
Component : https://www.parts-express.com/hivi-c...-set--267-4364

[SublimeZ]

https://www.sonicelectronix.com/item...-VAD10004.html will power front components and this sub nicely
https://www.woofersetc.com/c-23-subw...subwoofer.html

[m4kk]

Thanks mate, will this setup be good enough you think? What about the components. Solid? Or other recommendations. Thanks

Sent from my SM-G965F using Tapatalk

[Queef]

The NVX VAD10004 amplifier is going to run both , components and subwoofer.

The components are your choice , so if they make you happy ?

Pretty sure sub and amp will .

Cheers mate !

[m4kk]

The NVX VAD10004 amplifier is going to run both , components and subwoofer.

The components are your choice , so if they make you happy ?

Pretty sure sub and amp will .

Cheers mate !

Thanks bud. I didn't know if they were good quality/loud enough ect. Don't want anything to smash windows but nice and bassy with loud clarity up front ha.

Sent from my SM-G965F using Tapatalk

[Queef]

Ignore

[Queef]

Ignore

[Queef]

Thanks bud. I didn't know if they were good quality/loud enough ect. Don't want anything to smash windows but nice and bassy with loud clarity up front ha.

Sent from my SM-G965F using Tapatalk

I think the components @ 2 ohms along with sub @ 2 ohms will make you happy ( loud is great !)

[BigAl205]

This sub is going to get full power (500)
https://www.woofersetc.com/sd-3-10-d...subwoofer.html

Being dual voice coil (4 ohm) means when wired in parallel it will equal 2 ohm final load.

This sub cannot be wired to a 2 ohm load ( only 1 ohm or 4 ohm )

NVX VAD10004

• RMS Power Rating:
  
  • 4 ohms: 150 watts x 4 chan.
  • 2 ohms: 250 watts x 4 chan.
  • Bridged, 4 ohms: 500 x 2 chan.
  
  

Why would you run a sub at 2 ohms when the amp is only rated at 4 ohms bridged?

I think the components @ 2 ohms along with sub @ 2 ohms will make you happy ( loud is great !)

If burning up your amp makes you happy, then go right ahead.