2002 Acura RSX Type S (3-Way On Axis Rebuild Alpine/Audison)

[AsianInvasion]

I'm still waiting on the closed cell foam and reticulated fast dry foam to complete the midbass in the doors.

I ordered a sub enclosure from concept enclosures online. Its pretty much a subwoofer box for a 10 with 2 plexiglass amp racks under a false floor. I will post a picture of the enclosure when I am at home. They have great customer service! They did a very good job and made the enclosure with custom cut outs for the amps I have. They were very quick to reply and had great customer service.

I figured I would work on the wiring during the week for a few hours a day. I already messed up on the wiring for the first amplifier . I had to remove the bottom piece of wood from the amp rack and reverse mount the amplifier. This way the wires are run in the proper direction.

[AsianInvasion]

Got a little more done on the wiring.

[AsianInvasion]

Here are some pics of the old fiberglass sub enclosure that will be replaced by the new box and false floor. Cool thing is I can still retain the spare tire.

[AsianInvasion]

Here is are some pics of the box from concept enclosures.

[AsianInvasion]

Finally finished up the doors. I added a layer of CCF and added some fast dry reticulated foam around the midbass driver. This helps avoid moisture when mounted in the door panel.

[AsianInvasion]

Got the power and ground wire good to go. Just need to mount and attach the amp rack.

[AsianInvasion]

I have the optical for the head unit ran to a splitter in the glove box. This allows me to add in an ipod our android phone with an optical out. I have been using a type c otg cable to a usb soundcard with optical out . This will be replacing the ipad as the main source.

[AsianInvasion]

Here are some pics of the old ipad dash that will be removed. Some pics of the Alpine dva-9860 installed.

[AsianInvasion]

inally fixed the rear seat release knob . Without the release, I couldn't put the rear seat down which was a major pita. I was able to use some quick drying ca glue and a chopstick to pull the release up. Once the seat was released I could use a screw driver to push the knob up. I should be good to wire up the amp rack and sub now.

[AsianInvasion]

Got the led lights and processor added to the amp rack. Just need to mount the sub and put the amp rack in the car. I hope everything works properly with no issues. I didn't make the amp rack super accessible and it weighs a ton.