Good morning,
Is there a recommended process for properly cutting and painting HDPE? I found a 24x48 sheet for $16 dollars that is white, and want to use it for an amp board. Suggestions other than grab a can of Krylon and go to town? Thanks!
Printable View
Good morning,
Is there a recommended process for properly cutting and painting HDPE? I found a 24x48 sheet for $16 dollars that is white, and want to use it for an amp board. Suggestions other than grab a can of Krylon and go to town? Thanks!
I've been working a lot with HDPE lately. I'm not too sure you're going to get paint to stick to it properly. Is yours textured or smooth? Maybe if you spend hours sanding it to get it roughed up and then find a special plastics primer. But, by the time you've done all that you could have purchased another material that is designed to take paint.Quote:
Originally Posted by bluedevil1
If you don't care as much about the quality of the finish then maybe you will be fine. Paint will scrape and chip easily but should stick well enough if all you want to do is hide the white.
I would suggest googling the topic.
Ge0
There is this fabrication guide that was posted a few years ago. Its currently behind a paywall
https://www.scribd.com/document/2521...ev-B-2013-01-2
This was the original link that is now 404 http://www.vycomplastics.com/files/t...0B_2013.01.pdf
You may be able to use some googlefu and find a free version.
Oh and HDPE is made so that stuff does NOT stick to it. Krylon plastic paint might stick but HDPE's job is to be chemical resistant. Good luck.
Silver paint marker stuck ok to it but was easy to wipe off with some acetone:
Attachment 11888
Oh, and here is how I cut it.
Attachment 11885
Attachment 11886
Attachment 11887
Ge0
hey bluedevil1 just vinyl wrap it jdm style or euro style lol
The glue won't hold long...Quote:
Originally Posted by diy.phil
Ge0
I agree with all of your sentiments Geo. After some searching, some advise to sand, then a primer/primer adhesive, then, then, then...probably just stick to MDF.
If I use any HDPE at all I will just make sure it's black to begin with. As for the vinyl wrap diy.phil, I don't think anyone wants to go there. But suede, that's got promise!
I ordered a bunch of HDPE to make speaker adapter rings. Plastic is needed for this application due to moisture. However, you don't need to build amp racks and other interior structures with it. MDF is fine there. I used HDPE because I had material left over and didn't want to bother painting or vinyl wrapping it.Quote:
Originally Posted by bluedevil1
Ge0