For Focal? VERY nice! And a 12TW3? Perfect setup right there. I like the layout with the AudioControl in the middle myself, might be more difficult for cable routing though.
Printable View
For Focal? VERY nice! And a 12TW3? Perfect setup right there. I like the layout with the AudioControl in the middle myself, might be more difficult for cable routing though.
I liked the middle as well, symmetrical lol The Focals are a funny story, was giving a few long time gamer friends hell about missing my birthday & I'd still take gifts. Frenchie looked up the Focals & laughed cause I said they're expensive & it was ≈$125 US at places they're familiar with. Bought two & shipped them to me at cost
The subs a bad decision eBay purchase, knew better but the pennies saved tempted me too much. Waited well past time it was due to arrive, seller never replies or shipped so they refunded me. Week later I got a notification it's been picked up by FedEx & is in route
Cable routing I'd planned to make a little easier by doing a riser between mounting surface for amps & lci & a base plate below. Run some wiring underneath & pass through holes or a milled slot. If that makes sense lol
3 doors wired up & deadened, little bit of progresshttps://uploads.tapatalk-cdn.com/201...cf25e0e8a7.jpghttps://uploads.tapatalk-cdn.com/201...821109778e.jpghttps://uploads.tapatalk-cdn.com/201...ce829f1cae.jpg
Sent from my Pixel using Tapatalk
Dropped the wire bundle in the pillars, clipped speaker leads, & soldered 18 gauge to go to LC7I & 16 gauge to the other side for mids to amp. Had to add a 16 gauge run in to rear doors for tweeters as well. Luckily I was able to pass them around the molex easy enough. Wrapped everything with Tesa tape, & will techflex from where it exits carpet on.. for bonus hp, or whatever lol https://uploads.tapatalk-cdn.com/201...0c4a081782.jpghttps://uploads.tapatalk-cdn.com/201...d22c8afe68.jpghttps://uploads.tapatalk-cdn.com/201...ca395be5f2.jpghttps://uploads.tapatalk-cdn.com/201...8091843a71.jpg
Sent from my Pixel using Tapatalk
A-pillars back in, tweeters high temp hot glued into trimmed factory mounts. Have a slight angle on them instead of completely off axis, half assed aimed center
Trimmed surrounding raised area, removed grills, & good enough for me. The pointless hidden techflex screams I'm bored lolhttps://uploads.tapatalk-cdn.com/201...59a9e1db8a.jpghttps://uploads.tapatalk-cdn.com/201...39bc1f2483.jpg
Sent from my Pixel using Tapatalk
Chassis grounds done, pos to fuse holders done, need to techflex back half of pos runs up to the firewall & fuse my 16 gauge primary run stillhttps://uploads.tapatalk-cdn.com/201...aace783a5c.jpghttps://uploads.tapatalk-cdn.com/201...8b4d0fecd0.jpghttps://uploads.tapatalk-cdn.com/201...8eef40bdc7.jpghttps://uploads.tapatalk-cdn.com/201...70881bd045.jpg
Sent from my Pixel using Tapatalk
Used 1/4 abs for the fuse holder mount. Caught 2 factory holes that we're being used luckily
Sent from my Pixel using Tapatalk