Picked up my first item for my build back during last year's Black Friday Sales, won't get into all the reasons, but I have finally started doing actual work on the car.
Started with the decklid:
- Lots of compound curves on the Mustangs deck lid and virtually no access to the outer skin
- When I ordered my CLD, I did it based on 25 to 50% coverage depending on the location
- Well it didn't take long and I was doing 100% coverage on the decklid despite the fact it may not need it - the mild case of OCD kicked in and I am going to need a bigger boat, wait that's another box (the 30 count one not 5)
- It isn't pretty but its as functional as its going to get
- I also forgot to take the final picture though this one is 98% done
Next was the wheel well:
- Would have been easier to start here and learn how really sticky this is and how to handle it before starting the decklid
- This wheel well is a tin can, no way anything less then 100% bottom coverage works here
- Haven't decide how much of the sides to do - the pre-made Amp rack I bought is tight to the wheel well and I wanted some CCF in there. Will have to rethink it
- The painter's tape shows where the legs of the amp rack lands, the amp rack stand-offs are in the wrong spot causing a variance of 3/8" across 25" inches so left to right the amp rack will go uphill, not happy about it, but bigger fish to fry out there...