With the big Adcom and the JL XD amp, the car needed a little more reserve power. Howard had this battery sitting around, so in the car it goes.
Start off with tracing where things are going to be located.
Looks good to me.
Threaded aluminum to mount the circuit breaker.
Like so.
Drilling holes for the mounting strap.
Last test fitting.
Carpeted and ready to install.
Mounting holes.
Mounted.
From underneath.
Last edited by jowens500; 07-20-2017 at 05:27 PM.
More auxiliary battery install pictures.
Mounting strap installed and ready for action.
Wired up.
Seat back in.
And finished. The wires run to the distribution block under the rear seats.
Primer......
Last edited by jowens500; 07-25-2017 at 04:34 PM.
Finally got the iPad dash modification done.
Dude! That's freakin awesome!
Thanks Al!