If I had half a clue what all that equipment was Chad, I would have exactly .5 clue. Nice work space!
I make the things that go bump in the night...
1 rackspace top is just a placeholder for the switch that turns on the contactors for the audio rig and a balanced output from the DSP.
2 rackspace under that is a panel that has the muting/mode switching for the DSP via control voltage and the VCA controls for the DSP, and a spare set of 1/4" inputs that the second VCA knob controls. (homebrew jobbie)
after that a parasound DA converter
1 space unit below that a Shure P4800 DSP 4 in 8 out and takes all the switches/VCA info from the above panel.
Then amps
1 Carver PM175 for garage speakers
1 Crown CT410 for JBL mains
1 Clair/Carver PM1.5M for sub
below that is a 13.8V linear supply for the ham radio shit
Then the bottom unit is a UPS for the computers (2) Networking gear, and some lighting, it runs off of 3 batteries parked behind the mess.
Here's the DSP and Panel without the spare inputs wired/mounted yet.
I'll post up the bench stuff a bit later... I gotta blaze out to a meeting.
and that's a lotta damn pepsi.
Sure beats "shit on the switch." it is on the first switch with the Variac so if shit gets out of hand I can kill the AC power without reaching over the device blowing fire to unplug it
The knob on the variac is labeled "HEET."