-
02-01-2022
#1
Member
Helix Auto Time Measurement
I went through the process, or tried, of performing the Helix Time Measurement. Followed all of the steps yet it failed due to not getting the volume into the "green" acceptable area. Thats even maxing out to full volume before distortion. Anyone else have this issue?
-
02-01-2022
#2
Re: Helix Auto Time Measurement
Check the gain on the mic in sustem settings on the pc, it’s a box in rew. So I presume there’s the same on windows itself
-
02-01-2022
#3
Member
Re: Helix Auto Time Measurement
Thanks, I will look. Makes perfect sense.
-
02-02-2022
#4
Re: Helix Auto Time Measurement
Make sure there are no linked channels. Even have to unlink virtual channels. Make sure Mic loaded into DSP.
-
02-02-2022
#5
Member
Re: Helix Auto Time Measurement
I was told the calibration file didn’t need to be loaded for the ATM. Just for the RTA. I ran it today and it seemed to have worked. The first few times it ran successfully but didn’t save the delay readings even when prompting them to save. I made sure Time Measurement was checked on the front page of the Time tab and then chose Time Delay on the settings page of the Time tab and it worked as it should. Thanks!
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Back To Top