Sub enclosure build. One note about the sub enclosure build is it was my first one. If you look you can see a difference in size from the first few pic to the final pics. Thats because I miscalculated my air volume the first go around. Got it right the second time. You may also ask about the aluminum block off plate. My local shop wanted to simply pop out my cab vent but I did not want to do that so that what pushed me to build my own.
Last edited by Eatmore Bacon; 06-24-2021 at 01:14 AM.
A quick not about the amp rack. This is my first build so a lot of this was a learning experience. The amp rack set perfectly in the footprint that I measured it for. The only problem is the rear seat back rest would not lock into place after installation so I had to utilize lower standoffs. Looked good while I had them on though.
Hybrid Audio Technologies X3-PP midrange installation.
Attachment 15952
Attachment 15953
Attachment 15954
Attachment 15955
Attachment 15956
Attachment 15957
More to come.
Looking good, I was following this on diy. Good luck with your mid bass issue.
Thanks! Almost there!