Seeing if anyone can assist with the wiring information on Chrysler/Ram/Jeep/Dodge UConnect 8.4 head units. Finding any information on these for a Challenger has been a dead end so far. Seems like your, "typical" owner of these cars believes that's the Beats Audio setup is one of the finest available, just needs more bass
Soooo... I'm looking for the speaker wire colors, and perhaps where you can even tap into them. Seems my car has the Alpine 6-speaker setup, with two 3.5" in the dash, two 6x9" in the doors, and two 6.5" in the rear deck. The one install I could find with any bit of decent information, said the by nines cover 400Hz and down, the 3.5" are 400Hz and up. Just about every other install says the rears are full range, and they tap them for their subwoofers. When using a tone generator from my phone via Bluetooth streaming, I could verify the dash and door speakers to be very close to those numbers, but the rear speakers seemed to start rolling off around 80Hz. Can anyone confirm or deny this?