2 Attachment(s)
MB Quart MB Quart ZA2-1000.4
I recently purchased an
MB Quart ZA2-1000.4.... It has two x-overs one for channels 1&2 and one for channels 3&4. It is also bridgeable. My question is can i use the lowpass x-over for channels 1&2 and bridge them, to run a
12" sub. Then use the highpass x-over for channels 3&4 and leave them unbridged to run two 6x9'S. Or do they all need to be Bridged.. Or all need to be unbridged. Thx in advance for any help...
Re: MB Quart MB Quart ZA2-1000.4
You are trying to run it in 3 channel mode. This is perfectly ok to do.
This is best shown on page 2 of the manual in the picture marked "4ch - Mixed Mono"
https://assets.sonicelectronix.com/m...art/z2amps.pdf
Re: MB Quart MB Quart ZA2-1000.4
Any idea what the RMS wattage would be and the impedance
Re: MB Quart MB Quart ZA2-1000.4
If I wire it like this would it be enough or to much power for a Pioneer TSW311D4 12" Subwoofer with dual 4-ohm voice coils. Max power handling: 400 watts RMS (200 watts RMS per coil) / peak power handling: 1,400 watts.. Im not looking to thump the neighborhood, Just want my system to sound really good in the vehicle without burning something up, If it thumps the neighborhood, well then "bonus"
Re: MB Quart MB Quart ZA2-1000.4
Good choice on sub !
https://www.sonicelectronix.com/item...TS-W311D4.html
Fs = 43 Hz ( tune to that )
Series wiring equals 8 ohm load amp sees and parallel wiring equals 2 ohm load amp sees.
2 ohm will cause more current to flow thru amp , thus causing more heat.
Usually a bridged amp can only handle 4 ohms minimal , so 8 ohms is what I'd reccomend.
Yup 4 ohms bridged.
https://www.sonicelectronix.com/item...-RA1000.4.html
As ohms double to 8 , watts gets cut in half for output to sub
Re: MB Quart MB Quart ZA2-1000.4
https://www.sonicelectronix.com/item...PX2000.1D.html
@ 2 OHMS YOU'LL get 500 watts ( perfect ) and it has a subsonic filter , you will need one with a ported box.
Re: MB Quart MB Quart ZA2-1000.4
You can use up to 1 ought wire on ZA ? Whatcha plannin on runnin ?
Using a fuse ? It is reccomended to install one as close as possible to battery.
Re: MB Quart MB Quart ZA2-1000.4
I ordered i kit has 4g power and 4 g ground plus inline fuse holder with 80 amp fuse
Re: MB Quart MB Quart ZA2-1000.4
Re: MB Quart MB Quart ZA2-1000.4
could we get some gut shots. would be interested to see what the board looks like