1 Attachment(s)
REW 'Match response to target' help
Every time I try to Auto EQ in REW I presented an error dialog that says "The match range doesn't overlap the range of measurement".
I assume the match range is 20-200 in this screenshot but where is the range of measurement at that I am not matching?
Attachment 17808
Re: REW 'Match response to target' help
Try adjusting the values in the lower right corner in the filter tasks section?
Or, you could share your REW save file an let someone tinker with it to see what they can find?
Re: REW 'Match response to target' help
I have played with all kinds of different values. Sometimes a measurement works and sometimes it doesn't.
There has to be something simple that I am doing wrong.
Re: REW 'Match response to target' help
I just tried to auto eq sub signal and it worked fine this time. I don't understand what the heck is going on.
Here are the measurements:
Re: REW 'Match response to target' help
I have this error sometimes as well. When changing from 1/48 smoothing to 1/24 smoothing this error dissappears for whatever reason.
2 Attachment(s)
Re: REW 'Match response to target' help
I downloaded your measurements and had no issues...
here is the auto eq for the "left" measurement.
Attachment 17819
and here is the "right"
Attachment 17820
If you are working on only one driver, or some part of the curve other than the whole curve, you should use "Speaker Driver" as the target type and enter the HP and LP crossover points you desire, which should be the same ones you entered in Jazzi's spreadsheet to create the curves.
Re: REW 'Match response to target' help
I found that if I save the measurements, close the app, and re-open it works fine.
I will try changing from 1/48 to 1/24 smoothing to see if that makes it work too.